As soon as I changed it back to my mixture, they started feeding again. They would not even go close to the feeder with the store bought mix and the mixture was red. I did this after they had been feeding on my mix only. I put my 1 part sugar to 4 parts water mixture in one feeder and a store bought brand mixture in the other feeder. I have 2 hummingbird feeders next to each other and I tried an experiment last year. We had great use of our feeder all last summer with no hummingbirds getting stuck. There is also no gap around the outside for the birds to get stuck in. You can see in the picture of one feeding above that it is actually at quite an angle. Ours actually has quite wide holes in the top (wider than they look in the picture above – maybe hole-punch sized) – so hummingbirds are not required to stick their beaks in straight down. Also, there appear to be some feeder designs that allow hummingbirds to get stuck in the feeder. We will be using homemade sugar + water with no dye when we put the feeder back out this summer. While there doesn’t seem to be any evidence that red dye is actually dangerous to hummingbirds, the red color is the food is not necessary to attract hummingbirds as long as your feeder itself is red. SAFETY UPDATE: Some concerns have been raised about our feeder design and hummingbird food dye. Within 3 days I heard hummingbirds near the feeder and saw them on the fourth! While this is probably because of the large number of hummingbirds in our area, hopefully your homemade hummingbird feeder will attract them too! It is a pretty sturdy hanging method and has already survived a couple of thunderstorms. I tied two loops around the bottle, one loop for each indentation and then tied the hanging rope from these two sturdy loops. Powerade bottles are shaped nicely such that you can hang them easily with thin rope (I didn’t have a gatorade bottle, it might be the same with them). Once all of the holes are cut, it’s time to get the feeder ready to hang. Put the gatorade bottle through the hole in the tupperware lid (from the top) and fasten the gatorade bottle lid to the bottom of the tupperware lid. In the end, the humingbird food should only come up to the level of the powerade lid and won’t actually fill the whole tupperware container. The hole needs to be big enough so that the hummingbird food fills the tupperware container, but not so big that it overflows. One of the trickier holes to cut is in the top of the powerade bottle. Make sure to leave enough of a ledge for the hummingbirds to sit on. Next, cut four small holes near the corners of the top of the tupperware container for the hummingbirds to drink out of. The hole needs to be small enough so that when the lid is screwed back onto the bottle, the tupperware lid is stuck between the two. Once that’s done, check to make sure that the powerade bottle fits through the hole and the lid can be screwed back on. Now cut a whole in the center of the tupperware top the size of the opening to the powerade bottle. hummingbird food (can be bought or made yourself)įirst, take the lid off of the powerade bottle (be sure to hold on to it!) and mark the center of the top of the tupperware container (mine is not very well centered). red, shallow, square tupperware container The parts I needed for the hummingbird feeder: I told her I would make one instead! Something that I thought could be pretty complicated turned out to be pretty easy. A while back, Julia expressed interest in a hummingbird feeder, but I wasn’t excited about paying 15+ dollars for some molded plastic.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |